Team:TU Eindhoven/Microfluidics/Droplet Device

Droplet Device

To answer the questions mentioned at the introduction, a droplet device with a single oil inlet and a single water inlet is used (Figure 1). Both channels will end in a so called flow-focusing cross junction, where the droplets will be formed. The fluids will first pass a filter to minimize blockage at the cross junction nozzle. The curved channels just before the cross junction are fluid resistors and will create a laminar flow. It is possible to control the droplet size and droplet formation speed, by alternating both the oil flow as the water flow.

For an AutoCAD design of this microfluidic droplet device, download here. Design by Leroy Tan, Boris Arts & Rafiq Lubken.

Figure 1. A droplet device with 1 oil inlet (top), 1 water inlet (middle) and an outlet (bottom). Number 1 is the filter and number 2 is the flow focusing cross junction where the droplets are formed.

Bibliography

H. Huang and D. Densmore, “Lab Chip.” 2014.

D. J. Campbell, K. J. Beckman, C. E. Calderon, P. W. Doolan, R. H. Moore, A. B. Elis, G. C. Lisensky, "Replication and Compression of Bulk Surface Structures with Polydimethylsiloxane Elastomer." J. Chem. Educ. Vol. 76 , 537(1999).

Mcdonald, J. Cooper, David C. Duffy, Janelle R. Anderson, Daniel T. Chiu, Hongkai Wu, Olivier J. A. Schueller, and George M. Whitesides. "Fabrication of microfluidic systems in poly(dimethylsiloxane)." Electrophoresis 21.1 (2000): 27-40.

Mazutis, L., Gilbert, J., Ung. W.L., Weitz, D.A., Griffiths, A.D. & Heyman J.A. (2013). Single-cell analysis and sorting using droplet-based microfluidics. Nature, 8(5), pp. 870-91.

Song H, Chen DL, Ismagilov RF. Reactions in droplets in microfluidic channels. Angew Chem Int Ed Engl. 2006;45:7336–7356.