Team:Evry/Model/pcb model
From 2014.igem.org
(Difference between revisions)
Line 13: | Line 13: | ||
<a href="https://2014.igem.org/Team:Evry/Biology/Sensors#PCB_construct">our PCB construction</a>. <br/> | <a href="https://2014.igem.org/Team:Evry/Biology/Sensors#PCB_construct">our PCB construction</a>. <br/> | ||
We first modelled the behaviour of RFP production regarding PCB absorption to determine if our sensing strategy was viable. | We first modelled the behaviour of RFP production regarding PCB absorption to determine if our sensing strategy was viable. | ||
+ | However, we first tried to create a particule system of our cell including | ||
<h3> Model description </h3> | <h3> Model description </h3> |
Revision as of 03:53, 18 October 2014
Pcb Model
PCB sensor model
Introduction
After considering the water flux and pollutant motions in our sponge, we investigated the sensing power of
our PCB construction.
We first modelled the behaviour of RFP production regarding PCB absorption to determine if our sensing strategy was viable.
However, we first tried to create a particule system of our cell including
Model description
According to our device, RFP production is controlled by BphR1 promoter. This promoter is induced by the BphR2-PCB complex. Thus our RFP production will depend on the dynamic of BphR2-PCB complex. On one hand, we used a simple description of the RFP production.![](https://static.igem.org/mediawiki/2014/f/fe/Team_EVRY_GFP_eqn.png)