Team:BIOSINT Mexico/Results

From 2014.igem.org

Revision as of 03:26, 18 October 2014 by AldoHC (Talk | contribs)

Chassis.png

Results

Red Light Switch

We fused the promoter PCMV (BBa_K747096) to a YFP reporter (BBa_E0030).

In order to measure its expression, we culture transformed E.coli in agar plates and measured the fluorescense intensity every 45 minutes. After that, we obtained the following data. [Fig.1]

Figure 1 YFP intensity every 45 minutes.

We made three repetitions, so in order to model the equation, we obtained the mean measure, therefore:


Figure 2Media YFP intensity every 45 minutes.

We analysed the data and using the Wolfram Mathematica software, we obtained the following equation that fits the data. If we plot this equation, we obtain:

Model1res.png

Where we can see that the intensity of YFP grows directly proportional to the time and concentration of the molecule.

Figure 3Intensity YFP vs time.

Mer Operon Expression

In order to measure the mer operon expression fused the composite to a GFP reporter and analized the bioremediation by measuring the change of the concentration of methyl mercury in the media. First, we measured the GFP fluorescense intensity every 45 minutes.

5res.png

As we make three repetitions, we take the mean values as input data for the regression. The analized data was:

6res.png

For the regression, we used the Wolfram Mathematica software and obtained the equation:

Model2res.png

Thus, if we plot the equation we obtain that:

Meperdi.png

And, as we see in the graph, GFP expresses directly proportional to time, given the strenght of the promoter upstream. Then, as GFP expresses at aproximately the same rate that the mer operon proteins, it is posible to infer that the GFP concentration given any time is the same as the mer operon proteins concentration attached upstream. The change in the concentration of methyl mercury was also measured. We choose to measure it instead of the mercury accumulated inside the cells because it was easier. The collected data is provided in the table:

Ul1.png

As in the other experiments, we analyzed the mean values of the concentration in order to make the regression:

Ul2.png

Obtaining the polynomial equation:

Model3res.png


And, if we plot the equation we obtain the following graph:

Ul3.png

That, at short term, fits the behavior of the expected values.