Alcohol dehydrogenase (AdhA)

We found out, that the AdhA from Lactococcus lactis is the best alcoholdehydrogenase in literature (Atsumi et al., 2010). For that reason we want to increase the production of isobutanol by putting the adhA gene behind our producing pathway. The adhA from L. Lactis was not available as a BioBrick so we designed a new part which contains the coding sequence of the adhA gene from L. Lactis (BBa_K1465301). You can find our approach in the following sections.

Cloning

For the isolation of the adhA gene from L. lactis we first had to isolate the DNA of it. Afterwards we tried to amplify the adhA gene with the primer rev_pSB1C3_adhA and fw_adhA_pSB1C3. Via the primer the ahdA genes was combined with the RBS BBa_B0034. Together with the amplified backbone we performed a Gibson Assembly. All verifications showed that our cloning was successful but our backbone was pSB1K3 and not pSB1C3. For that reason we performed a successful recloning in pSB1C3 and pSB1C3_adhA is our part BBa_K1465301 was ready for usage.

For the characterization of our BioBrick BBa_K1465301 we performed a BioBrick Suffix Assembly with the pSB1A2_T7 (BBa_I719005 ) and our part. We wanted the new created part in pSB1C3 too, so a successful recloning in pSB1C3 was done resulting in pSB1C3_T7_adhA. The new part can now be found as the BioBrick BBa_K1465304.
Additionally we performed a BioBrick Prefix Assembly with the pSB1C3_ptac (BBa_K731500) and our part. The successfully created part pSB1C3_ptac_adhA can now also be found as the BioBrick BBa_K1465305

Expression

For the protein expression analysis of AdhA we made a cultivation of E. coli KRX with our construct pSB1A2_T7_adhA. Samples were taken like explained in the cell lysis for a SDS-PAGE Protocol. Protein expression was induced with rhamnose when the culture reached a OD₆₀₀ of 0,8. The first sample was taken right before the induction. Additionalle we took samples one, two, three and 20 hours after the induction. Of these samples, we made a SDS Page. Figure x shows the picture of this SDS Page.

Figure x: SDS page from pSB1A2_T7_adhA.
The mass of the AdhA is ~ 35 Da

You can see that the size of the band at a mass of 35 Da increases the later the sample was taken. There is a significant difference between the size of the bands of the point of induction an 20 hours later.
This result is as we had expected it.

Anaerobic Cultivation

We cultivated anaerobic conditions in LB. We focused on growth characteristic.

Conclusion

References

• Atsumi S, Wu TY, Eckl EM, Hawkins SD, Buelter T, Liao JC. 2010. Engineering the isobutanol biosynthetic pathway in Escherichia coli by comparison three aldehyde reductase/alcohol dehydrogenase genes. In: Appl. Microbiol. Biotechnol 85, 651–657