Team:Aachen/Interlab Study/Hardware
From 2014.igem.org
(→Open Source DIY Hardware) |
(→Open Source DIY Hardware) |
||
Line 24: | Line 24: | ||
This cuvette holder can be used for both devices: the whole in the bottom is used for fluorescence measurement, the two opposite wholes are used for the light sensor and the LED for optical density measurement respectively. | This cuvette holder can be used for both devices: the whole in the bottom is used for fluorescence measurement, the two opposite wholes are used for the light sensor and the LED for optical density measurement respectively. | ||
+ | |||
+ | === Hardware Requirements === | ||
The key ingredients for our combined optical density/fluorescence (OD/F) device then are: | The key ingredients for our combined optical density/fluorescence (OD/F) device then are: | ||
Line 34: | Line 36: | ||
* LED for optical density (for 600nm we recommend: DIALIGHT - 550-2505F ) | * LED for optical density (for 600nm we recommend: DIALIGHT - 550-2505F ) | ||
* LED for fluorescence (any 450nm blue works for iLOV, 480nm for wtGFP ) | * LED for fluorescence (any 450nm blue works for iLOV, 480nm for wtGFP ) | ||
+ | |||
+ | The case is from acrylic glass. The construction plan can be downloaded from [2014.igem.org/Team:Aachen insert link here]. | ||
+ | |||
== Fluorescence == | == Fluorescence == | ||
+ | |||
+ | Also general information | ||
+ | |||
+ | === Characteristic Curve === | ||
== Optical Density == | == Optical Density == | ||
+ | |||
+ | Some general information | ||
+ | |||
+ | === calibration === | ||
{{Team:Aachen/Footer}} | {{Team:Aachen/Footer}} |
Revision as of 22:35, 22 August 2014
|
|