Team:Toronto/Notebook

From 2014.igem.org

Revision as of 01:43, 18 October 2014 by Samantha.chow (Talk | contribs)


  • Week 1

    • picked single MG1655 and pTRC99A strains into liquid culture, incubated overnight (pTRC99A in LB+Amp)
      • miniprepped pTRC, O/N culture of MG1655
      • MG1655 did not grow on antibiotic plates, so stocks are good!
    • prepped DNA for transformation – pCas9 and RFP reporter
    • made MG1655 electrocompetent – electroporate and plated transformants, incubated overnight
  • Week 2

    • transformation of RFP, pCas9, GFP, fmt into NEB5alpha
      • transformants plated and incubated overnight
      • then inoculated into liquid culture, incubated overnight
    • overnight culture of MG1655 and pTRC99A
    • Miniprepped RFP and pTRC99A
      • tested restriction enzymes EcoRI, Xbal, SpeI, Pstl on miniprep and ran on gel w/ uncut as control
      • cut plasmids were too faint to see – need more concentrated DNA in preps!
    • O/N cultures of RFP, pCas9, GFP from transformation
    • miniprep of O/N cultures of transformants and pTRC99A
  • Week 3

    • miniprep again, greater volume (3mL) for RFP, GFP, Cas9, pTRC99A + nanodrop
      • digest product (w SpeI, EcoRI, cutsmart) and run on gel
    • O/N culture from plate of extra biobrick, RFP, MG1655
    • start RFP and MG1655 liquid cultures for the RFP spectrum measurements in the afternoon
      • RFP grew slowly and was transformed into NEB5alpha instead of MG1655
    • digest 8 samples from yesterday’s miniprep of 8 biobrick cultures, load and run gel of digest
    • oligos and gblocks arrived
    • did PCR of pCas9 and pTRC99A chunks
    • Started MG1655 liquid culture for making chemically competent
      • make chemically competent cells, transform RFP into them, PCR purification, run on gel
  • Week 4

    • miniprepped pCas9 + pTRC99A (w 7mL of cells)
    • did gel extraction – cut out pCas9 + pTRC digests – PCR both as well as nanodrop
    • Mon/Tues = PCR w mastermix, Wed = make comp MG1655 and heatshock RFP, Thurs/Fri = confirm RFP and Marafini protocol/golden-gate assembly
      • PCR from the Friday before did not work
      • so do lots of minipreps from 10mL cultures and start over, use larger volumes for digests
      • DNA eluted into collection tube but saw salt contamination when nanodropped therefore redo miniprep…
      • miniprepped pTRC and pCas9 and then nanodropped – results were good so created gel for next day, as well as a digestion
      • digested/ran the gel/extracted, will nanodrop gel extraction – if worked, try PCR again
  • Week 5

    • Wed. minipreps were good (however possibly from just high free nucleotides), gel extraction failed (no DNA at the end and a lot of salt contamination) – so just PCR from miniprepped plasmids
    • digest and run gel of digest at the same time!
      • PCR of pTRC and pCas9 – have also been digested
      • ran gel! 5 part sample, 1 part loading dye
    • if PCR worked, digest PCR product w DpnI – got nothing for pCas9 though on the gel (to be re-PCR-ed), but bright bands for pTRC
    • competent MG1655 also done
    • PCR of miniprep C1 #1 of cas9… did 10 x 10uL reaction using gradient temps in 58-68 range
      • run on gel to see if PCR worked
      • PCR gel showed 2 weak bands – either not enough DNA or PCR failed
    • heat shock transformation for MG1655 w RFP plasmid but very few colonies on CM plate
  • Week 6

    • PCR product (???) run on gel, pick most successful PCR
    • DpnI digest following protocol in NEB Gibson manual Transform RFP  MG1655, O/N cultures
    • pCas9PCR product visible on gel
    • DpnI digest + PCR cleanup of digest (ended up not having enough DNA)
    • plating of transformed RFP into DH5a
    • processed PCR – ran on gel, DpnI digest also ran on gel, PCR cleanup, nanodrop (worked well)
    • needed to transform pCas9+spacer plasmid  RFP DH5a
  • Week 7/8

    • transform RFP  BL21(DE3)
    • PCR of pCas9, pTRC99A
    • Gibson – pick 8 colonies, make O/N colonies, try to PCR form reaction to get 4-fragment superchunk
    • Maraffini – use Anderson high for 4 fragment (phosphorylation + annealing of spacers if we get a lot of DNA), otherwise using Aug 18 miniprep do a BsaI digest
      • got colonies from Gibson
    • 3 things in parallel:
      • miniprepped plasmids from Gibson transformants from O/N liquid cultures (need to be sent for sequencing) , plasmids digested w E+P and to be run on gel
      • making competent MG1655 – transform RFP into it
      • tried BsaI digestion and gel extraction on Stanford-brown pCas9 (for Marafini/Golden-gate), does not seem to work even w large volumes
    • look at plates from transformation, run E+P digests on gel – if the digests look wrong size, do colony PCR on rest of Gibson colonies on plates
      • use fwd/rev primers for cas9 and p!TRC chunks
      • if correct, also PCR the 3-fragment superchunk from the miniprep plasmid by using Cas9 fwd with p!TRC rev primers
    • try a gel-extraction protocol…
  • Week 9

    • Main thing – GIBSON ASSEMBLY
    • screened 8 colonies – miniprepped, EcoRI + PstI digest  wrong product, non-specific assembly
      • extend gblocks (Anderson high + tracr) so more overlap, try Gibson again
    • did digests of plasmids w one restriction enzyme instead of double digest + run gel (for less confusing results) – used miniprep #1-4
    • made O/N cultures from first Gibson reaction #9-15 – miniprepped and streak out plates
    • minipreps #5-8 from earlier digested w EcoRI and PstO (separately), run on gel
    • take 2 minipreps, do 3 reactions on each – EcoRI only, PstI only, both EcoRI + PstI
  • Week 10

    • miniprep out RFP plasmid to be used for putting biobricks into pSB1C3, will want to screen for non-red colonies at the end of the process
    • unable to do digest because nanoprep of all 3 minipreps was too low
    • primers arrived – ran PCR w new primers
      • also digested RPF
      • run digests on gel (1/2 thickness)
    • ran the original gblocks w extended gblocks – not enough of original gblocks to show up on gel
    • combined PCR reactions of tracr gblocks into one, same with Anderson High PCR products
      • purified both
      • PCR purified Cas9 array from a PCR in August
      • purified p!TRC chunk found
      • all 4 to be used for Gibson assembly!
    • glycerol stocked 3 tubes of colonies from first Gibson attempt (#3, 4, 7)
    • transformed Gibson in NEB5alpha, ½ of each reaction tube into a total of 4 NEB5alpha – 4 tubes plated onto 2 plates each = total 8 plates incubated
    • on Friday, found colonies from the Gibson assembly and did colony PCR
    • colony PCR primers were designed to cover the seams where the 4 chunks joined
    • mixed the template DNA and biobrick primers for the Cas9-array chunk, but did not add the master mix yet (done later)
  • Week 11

    • ran Gibson colony PCR on gel – colonies #3 + 6 have correct bands, started O/N cultures of them w cell suspensions from colony PCR
    • miniprep and glycerol stock them (low copy plasmid – do 3uL miniprep)
    • PCR of cas9 chunk – run on gel, see if band is at 4595
    • using RFP miniprep from earlier, digest w EcoRI and PstI
      • linearised plasmid digested same way (if DNA dissolved – was left sitting overnight to dissolve)
    • nothing on gel at correct size…. only used 1uL of DNA for gel though
    • digest ~1000ng of Gibson miniprep from 2 colonies w EcoRI and PstI, run on gel
    • run 5uL of tube labelled C6*
    • cas9-array chunk biobrick extension PCR barely worked – not enough DNA after PCR purification but tracr chunk biobrick PCR worked
      • digested/ligated into pSB1C3, transformed into competent cells
      • Gibson colonly #3 didn’t assemble correctly, only produced 1 band from E+P digestion
    • transformed ligation into NEB5alpha – after 2 hour (actual = 10 min) incubation in SOB, pipetted into 2mL LB Cm and grew overnight
    • miniprepped to see if it grew and packed it up for shipping!