Team:Oxford/realisation bioremediation

From 2014.igem.org

(Difference between revisions)
(Undo revision 129868 by JHoffman (talk))
Line 40: Line 40:
<br>
<br>
-
<h1>Introduction about the realisation of the bioremediation</h1>
+
<h1>Introduction</h1>
-
Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation Lots and lots of info about Realisation
+
We thought that it was important to think properly about how the system would be implemented in reality and to keep that in mind throughout the whole project. This meant that we could keep our research constantly focussed on the end product.
 +
<br><br>
 +
As such,  we designed the complete system on the CAD software SolidWorks. This enabled us to demonstrate how the project could actually be incorporated into the real world. It also allowed us to overcome flaws in the design before we started construction. Pictures taken from SolidWorks are shown below. In addition to this, we used 3D printing to <u>construct the biosensor part of the design</u>.
 +
 
<br><br>
<br><br>
</div>
</div>

Revision as of 17:12, 28 September 2014


Realisation


Introduction

We thought that it was important to think properly about how the system would be implemented in reality and to keep that in mind throughout the whole project. This meant that we could keep our research constantly focussed on the end product.

As such, we designed the complete system on the CAD software SolidWorks. This enabled us to demonstrate how the project could actually be incorporated into the real world. It also allowed us to overcome flaws in the design before we started construction. Pictures taken from SolidWorks are shown below. In addition to this, we used 3D printing to construct the biosensor part of the design.