All transformations were done in E. coli. Preparation of the backbones was done in DH5alfa, while for transformations with the clusters JM109 was used.
Growth experiments were conducted with fusaric acid concentrations ranging from 0 to 250 ug/ml were performed on Eschericia coli (Strains DH5alfa, BL21 and JM109), Bacillus subtilis and Pseudomonas putida. After 18 hours of incubation at 37 degress celcius, OD 600 measurements were taken.
NOTE: After ordering new fusaric acid later in the project, it was found out that the fusaric acid used in this experiment was not the same strength, with the old one most likely being (partially) degraded. Therefore data from this experiment is not used.
Since some soil bacteria are known to be able to degrade fusaric acid (FA), a HPLC experiment was started to test P. putida(PP) for fusaric acid degradation and carbon utilization. M9 media was used with glucose/fusaric acid(250ug/ml) or both as a carbon source.
For the HPLC the following settings were used.
Based on the initial results a more elaborate experiment was started in duplo. Six samples would be grown in duplo:
Using an automated platereader, time based growth was measured on P. putida, to see the response to different concentrations of fusaric acid.
All gene clusters were isolated using PCR. The following primers were used. Temperatures were calculated using NEB Tm Calculator. If the initial temperature did not work, the Tm was lowered by 3 degrees and a duplo with 1 ul of DMSO was done.
No PCR results could be obtained for this cluster, possibly the DNA was degraded during the time spent shipping. Since the other PCRs did give results, it was chosen not to continue with this gene cluster
Initially pSB1C3 was chosen as a backbone. To serve as a repressible promotor J04500 was incorporated between the EcoRI and the XbaI site, because all the gene clusters to be integrated contain illegal PstI sites. Xba and SpeI were used to insert the gene clusters into the backbone vector.
All transformations using the fusaric acid resistance clusters proved unsuccesfull. Any colonies obtained were proven by colony PCR or restriction digestion to not contain any inserts. Since the expression of membrane proteins can often be toxic, it was considered that the leakiness of the pLac promoter in combination with the high copy pSB1C3 plasmid might prove toxic for our host organism. Therefore it was decided to construct low copy backbones using pSB3K3 and pSB4K5.
To prevent toxicity from leaky expression of potentially toxic membrane proteins low copy number backbones pSB3K3 and pSB4K5 were digested with EcoRI and XbaI to insert J04500 according to standard protocols.
As an alternate way to see if the proteins that were tried to be expressed were toxic, it was decided to isolate the three genes from the FDT-123 cluster seperatly. This could give insight in which of the genes would cause the potential toxicity. Primers used were:
Using the low copy backbones transformations results were obtained. The transformation of the FDT-123 cluster in pSB4K5.
Several more tries were done to characterize the possible fusaric acid breakdown of P. putida, however, several technical issues with the HPLC were had so no further results have been obtained yet.
iGEM Wageningen UR 2014. Send us an email, or follow us on Twitter and Facebook!
For more information about iGEM, check out their website and Twitter!
"
