Fusaric Acid Sensing

Resistance to fusaric acid is found in several microorganisms, such as Stenotrophomonas maltophilia [3] and Pseudomonas putida [4]. This resistance to the toxic compound is due to a fusaric acid efflux pump, which pumps the acid out of the cell. After doing a literature search, we found out that there are a few proteins encoded in the genome of P. putida KT2440 which should confer fusaric acid resistance based on in silico prediction. The corresponding genes are all found placed in an operon cluster starting from pp1263 to pp1266 [4]. Upstream of this region and transcribed to the opposite direction we found the pp1262 gene whose predicted function is a LysR-type regulator.

Based on the above predictions and the gene topology, we hypothesized that since fusaric acid resistance from this cluster has not been confirmed through experiments it was worth to try to check if the theoretical regulator pp1262 can control the expression of the gene cluster through a promoter in the intergenic area. Based on this hypothesis, expression of the pp1262 protein should repress transcription of the operon cluster in the absence of fusaric acid. On the other side, when fusaric acid is present, repression should be relieved. To further support that this is how the system works and that fusaric acid does not activate the repressor leading to higher transcription rates of the resistance cluster we expect that when the repressor is overexpressed in P. putida to cause lower fusaric acid resistance because of lower depression rate of the promoter (Figure 1.) Hence, we isolated pp1262 and the intergenic region and put it into a BioBrick, effectively acting together as a fusaric acid inducible promoter (FAiP).

We decided to test and characterize the fusaric acid sensitivity and expression of this part by using different levels of fusaric acid. The promoter was tested using GFP and RFP reporter genes (BBa_I13507, BBa_I13504, BBa_J23100) as output. Each BioBrick part contains an RBS, a reporter gene and two terminators. The new constructs were expressed in P. putida to test for expression in the presence of fusaric acid.

To isolate the pp1262 gene and the downstream intergenic region, two promoters containing the RFC10 parts were used in a PCR reaction on the genomic DNA of P. putida KT2440. The product was ligated into pSB1C3 and transformed into chemically competent E. coli cells. The part was digested again and ligated upstream of several different reporter genes. BBa_I13507, which contains an RBS, mRFP and two terminators was successfully transformed. However, after sequencing it became clear that this BioBrick did not contain mRFP, making it unsuitable for this experiment. BBa_I13504, which contains an RBS, GFP and two terminators was used for further experiments. This construct was ligated and transformed into E. coli. Sequensing confirmed the successful assembly. This construct should only show green fluorescence in the presence of fusaric acid, and no fluorescence when fusaric acid is absent. The E. coli cells, containing the construct were grown on agar plates containing different concentrations of fusaric acid. At 140µM, there was no significant difference between the transformed cells and the control cells. At higher concentrations the cells died, due to their inability to pump the acid out of the cell. The construct was transformed into a different backbone (pSB1K3) and inserted into electrocompetent P. putida cells. The transformed cells were again grown on plates containing different concentrations of fusaric acid. A slight difference in colour could be observed between the transformed cells and the wild-type cells, indicating promoter is only active when fusaric acid is present. (See Figure 2.)

A growth experiment was performed in a 96-wells plate, containing 0, 55, 140, 285, 565 and 1415µM fusaric acid and both transformed P. putida cells and wild-type cells. After 18h, at a concentration of 285µM fusaric acid, the transformed cells showed more fluorescence than the wild-type cells, while both strains showed no fluorescence when no fusaric acid was added, indicating that the promoter is not active when no fusaric acid is present. After washing with PBS since GFP did not include an excretion tag, the wild-type showed no significant fluorescence, whereas the transformed cells clearly did, (see Figure 3.) indicating that the promoter is functional. Futhermore, the WT cells showed growth on all concentrations of fusaric acid. However, the transformed cells did not survive a fusaric acid concentration of 565µM and higher, indicating that the inserted vector decreased their fusaric acid resistance.

A new growth experiment was set up, using M9 medium instead of LB medium. In this experiment both the WT P. putida and P. putida containing BBa_K1493000 are grown in a 96-wells plate at 0, 85, 170, 255, 340 and 425µM fusaric acid. Furthermore, E. coli DH5α cells (WT and BBa BBa_K741002) were also grown in the same plate, but without fusaric acid. The transformed E. coli has a well characterized promoter (pLac) with the same GFP gene downstream. (See Figure 4.) By comparing the fluorescence of our fusaric acid induced promoter at different fusaric acid concentrations to this constitutive promoter, a characterization can be performed. pLac is used as a constitutive promoter, which has shown activity without induction of IPTG.

From these results, a couple of conclusions can be drawn. The hypothesis that the combination of the inhibiting LysR-type gene and the promoter in the intergenic region is indeed fusaric acid inducible is supported by the results of the growth experiment in Figure 4. To activate the promoter, the concentration of fusaric acid has to pass a certain threshold. To further support this hypothesis, it was observed that the transformed P. putida cells did not survive a fusaric acid concentration of 565µM or higher, possibly because of overexpression of the inhibiting gene pp1262, which would not only inhibit the activity of the GFP, but also of the original fusaric acid efflux pump in the original genome of P. putida, therefore unintentionally decrease the resistance of the host. Up to now, the regulation of this fusaric acid efflux pump was only theoretical. However, these experiments do not only give some good indications that the functioning of this promoter is indeed regulated by the induction of fusaric acid, but they also show that this regulator can actually easily be used for other purposes, such as detecting Fusarium oxysporum and producing anti-fungal agents in its presence. A fusaric acid detection system has not been developed before now, and the implications of this part could very likely exceed this iGEM project.

While performing mutagenesis on the BioBrick, an unintentional insert was introduced, causing a frame shift in the inhibiting gene. By introducing this part to P. putida and growing it at the same time as the tested transformed P. putida used in the previous experiments, the fusaric acid resistance can be compared between the two strains. Hypothetically, the new strain could have a higher resistance, because the overexpression of the inhibiting gene is dysfunctional and therefore cannot block the fusaric acid efflux pump in the original genome. Unfortunately, this has not been tested yet.

Resistance

Different gene cluster known to be related to fusaric acid resistance will be isolated from multiple different organisms. FusABCDE from Burkholderia cepacia [1], FDT-123 from Klebsiella oxytoca [2], FuaABC from Stenotrophomonas maltophilia [3] and PP1263-5 from Pseudomonas putida itself. These clusters will then be expressed under an IPTG inducible promoter (BBa_J04500) or a ramose inducible promoter (BBa_K914003) in order to test the resistance levels. Since all of the clusters contain multiple illegal PstI sites, it was decided to insert the cluster directly in the SpeI site of the biobrick suffix.
PP1263-5 from Pseudomonas putida could be isolated from the wild type strain used at our own facilities. The original strains referred to in the research papers for the other three organisms were not available. Therefore homologues genes, with high levels of sequence identity (>98%) were identified and obtained from microbial collections.

All clusters but FuaABC were successfully isolated by PCR but cloning proved to be more difficult. Initial attempts to ligate the cluster behind BBa_J04500 in psb1C3 and transform it into E. Coli yielded no results. Although colony PCR showed a positive colony in some cases of the FDT cluster, plasmids isolated from these colonies were not of the right size to contain the inserts. Sequencing one of these plasmids with the VR and VF2 primers showed insertion of a small fragment containing the end and start of the primer used to PCR the cluster and a small palindromic sequence of 8bp. (ATCGATGCTA)
Membrane proteins can potentially be toxic when expressed at a too high rate. Therefore the construct was inserted in to a low copy number backbone (pSB3K3 / pSB4K5). Additionally the three genes of the smallest cluster (FDT-123) were separately expressed to see if one of them was the cause of the possible toxicity.
Successful transformants were obtained in pSB4K5 for the whole FDT cluster, FDT-2 and FDT-3 under a pLac promoter. Once again the whole FDT cluster showed up successful on colony PCR, but failed to show the expected results when a restriction digest was done on isolated plasmids. Sequencing showed again inclusion of both the primers and a small palindromic sequence (TAGCATCGAT/ATCGATGCTA).
Given that both FDT-2 and FDT-3 were successfully cloned but the whole cluster or FDT-1 separately did not yield any results, FDT-1 , which has homologues proteins in all 3 clusters is the most likely cause for toxicity.

Expression of the complete cluster has not yet been achieved. More research is required to understand the function of the different parts of the resistance cluster. Ideally functionality could be proven using a FA sensitive knockout strain of P. putida itself with which could be restored by inserting the putative resistance cluster. After achieving successful expression, more insight could be achieved using protein interaction studies or GFP tagged proteins to determine localization.

BioBricks

BBa_K1493000, BBa_K1493002, BBa_K1493003