Team:Paris Bettencourt/Notebook/Foot Odor

Revision as of 17:34, 17 October 2014 by Marguerite (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

June

23-06-2014

Goal: To obtain single colonies of both Wt and mutant B.Subtilis

We received the wt (1A1) and mutant BKE24040 (isovalerate dehydrogenase beta KO), BKE24050 (isovalerate dehydrogenase alpha KO), BKE24080 (Leucine dehydrogenase KO) from BGSC on 23-06-2014. The wt strain (1A1) was on a paper strip. We received 3 strips from BGSC (Bacillus genetic stock centre). Where as the mutant strains arrived on perti-plates.

Procedure

We plated two strips in two different LBA plates. The plates were free from antibiotics. We placed the strips gently on the LBA and added 1 drop of sterile H2O. After few seconds we streaked the paper strip on the LBA and discarded the strip. The LBA plates were incubated at 37° C. We took single colony from the mutant B.subtilis petri-plates and streaked them on LBA+EM petri plates.

Results

Good growth of both the wt and mutant B.subtilis were observed followed by the overnight incubation

24-06-2014

To obtain single colonies of Wt b.Subtilis from 23-06-14 plate

Procedure

we took a single colony and streaked it on a new LBA with and w/o Erythromycin.

Results

No colonies in LBA + EM. Colonies observed in LBA w/o EM

27-06-2014

To prepare LBA and LB broth for B.Subtilis mutants

Procedure

We added 2.5 ul of the EM (20mg/ml) to 50ml of LB broth. We added 25 ul of EM to 250 ml of LBA and prepared the plates & stored them at 4° C.

30-06-2014

Goal: To prepare 10% glycerol stock of wt and mutant (BKE24040, BKE24050, BKE24080) B.Subtilis

Procedure

We inoculated Single colony of both wt (1A1) and mutant (BKE24040, BKE24050, BKE24080) in 5ml of LB broth supplemented w/o EM for wt and with EM for mutants. Incubated the colonies @ 37°C overnight. After the overnight incubation the tubes were stirred well. 750 ul of the culture is transferred to cryogenic tube and 750 ul of 60% glycerol is added to the culture to obtain 10% glycerol stock.

Entry	Strain	Resistance	Source	Strain	Glycerol Stock Label
sPB.011	BKE24040	EM	BGSC	B.subtilis with 2-oxoisovalerate dehydrogenase beta subunit knockout	G.11
sPB.012	BKE24050	EM	BGSC	B.subtilis with 2-oxoisovalerate dehydrogenase alpha subunit knockout	G.12
sPB.013	BKE24080	EM	BGSC	B.subtilis with leucine dehydrogenase knockout	G.13
sPB.014	1A1	-	BGSC	B.subtilis wt strain	G.14

The cryo tubes were stored at -20°C.

July

15-07-14

To perform colony PCR on mutant & wt B.subtilis to confirm the knock out of gene of our interest and also to confirm the presence of ERM cassette in the loci of the knocked out genes

Work plan:

BKDA alpha
Primer category	F	R	Deletion Strain	WT
Control primer	oPB.023	oPB.025	2944 bp (A)	2920 bp (B)
Deletion primer	oPB.023	oPB.029	2230 bp (1)	No Band (2)
Deletion primer (cassette reversed)	oPB.029	oPB.025	1653 bp (DP1)	No Band (DP2)
BKDA beta
Primer category	F	R	Deletion Strain	WT
Control primer	oPB.026	oPB.028	2869 bp (C)	2836 bp (D)
Deletion primer	oPB.026	oPB.029	1629 bp (3)	No Band (4)
Deletion primer (cassette reversed)	oPB.029	oPB.028	2179 bp (DP3)	No Band (DP4)
BCD
Primer category	F	R	Deletion Strain	WT
Control primer	oPB.020	oPB.022	2636 bp (E)	2714 bp (F)
Deletion primer	oPB.020	oPB.029	1529 bp (5)	No Band (6)
Deletion primer (cassette reversed)	oPB.029	oPB.022	2046 bp (DP5)	No Band (DP6)

Reaction mix:

Reagent	Volume (uL)
	20X
NF         ddH2O	236
5x Phusion HF Buffer	80
10 mM dNTPs	8
DMSO	12
DNA Template	1
Phusion Polymerase	4

PCR NEB Phusion DNA polymerase (thermocycler parameters)

Status	Temperature (°C)	Time (sec)	Process
Start	98	30	Melt
Melt	98	10	x35 Cycles
Anneal	52	30	x35 Cycles
Extend	72	90	x35 Cycles
Finish	72	300	Extend
Store	10	∞	Store

Procedure

After the PCR the reaction mix in the tubes were loaded on individual well. The 1X agarose gel was used for the electrophoresis. The 1kb plus ladder (thermo fisher inc.) was used for comparing the bands.

Results

30-07-14

To prepare a 100X synthetic sweat master mix

Procedure

Mix the chemicals mentioned in the table below and mix them properly to have a homogeneous mixture

Quantity	unit	Chemical
2.6	g/L	L-Leucine
0.3	g/L	L-Cysteine
30.3	g/L	L-Serine
8.1	g/L	L-Alanine
0.1	g/L	L-Arginine
4.3	g/L	L-Histidine
6.6	g/L	L-Threonine
3.2	g/L	L-Valine
2	g/L	L-Isoleucine
1.19	g/L	L-Lysine
2.1	g/L	L-Phenylalanine
3.4	g/L	L-Tyrosine
2.2	g/L	L-Asparagine
2.3	g/L	L-Glutamic acid
0.7	g/L	L-Methionine
0.3	g/L	L-Glutamine
5.5	g/L	L-Aspartic acid
8.6	g/L	L-Ornithine
7.3	g/L	L-Citrulline
0.1	g/L	L-Ascorbic acid
18	g/L	D-Glucose
0.4	g/L	Creatinine
5.5	g/L	Sodium pyruvate
12	g/L	Potassium hydrogen carbonate
0.2	g/L	NaH2PO4
5.7	g/L	Calcium sulfate

SHAKE THE VESSEL WELL BEFORE USE

Take 1.39 g/l of the above master mix and dissolve it in double distilled water. Add the fatty acids as per the requirement of your experiment. The pH of the synthetic sweat could be adjusted with the aid of NaoH (use the pH meter).

Note: Autoclave the glass vessel with 15g/L of agar to prepare the LBA+ synthetic sweat plates. If not autoclave the vessel without the agar for preparing the broth.

August

11-08-2014

To produce synthetic sweat without Fatty acids

Procedure

we are going to take 0.051 g (since the master mix was 100X) of the synthetic sweat master mix and dissolve it in one liter of distilled water. The PH of the synthetic sweat was adjusted to 6.5 with aid of Hcl and NaoH. The vessel was autoclaved and stored at 4° C for future use.

25-08-14

Smell test of WT and Mutant

Goal: Measure the smell intensity of WT versus mutant
Protocole: from LB Plate of 1A1, BCD, BKDAa, BKDAb: start 5ml liquid culture (times two).
(Media preparation: M9 minimal media, with glucose as carbon source. Add tryptophan to each of the culture.)
Put one colony with a loop in each tube, culture the tubes overnight at 37°c (150 rpm).
Then we do the same, expect that we add leucine to the mdeia (500µl of 1% Leucine into 4500µl of M9) We repeat the experience twice.


Next day, after 20 hours of culture, we take the OD: Exp01
1A1= 0.180
1A1+Leu= 0.264
BCD= 0.047
BCD+Leu = 0.472
BKDAa= 0.084
BKDAa+Leu= 0.128
BKDAb= 0.088
BKDAb+Leu= 0.114

Exp02
1A1= 0.422
1A1+Leu= 0.505
BCD=0.305
BCD+Leu =0.304
BKDAa=0.322
BKDAa+Leu=0.707
BKDAb=0.179
BKDAb+Leu=0.160

We use the tubes from the exp02 and start with three members of the team. We ask the volunteer to smell the samples (choosen randomly) and to rate the intensity between 0 and 5.

Results:
1A1= 4/3/2
1A1+Leu= 1/3/4
BCD=1/3/1
BCD+Leu =2/2/0.5
BKDAa=1/3/1
BKDAa+Leu=1/2/3
BKDAb=Not grown enough
BKDAb+Leu=Not grown enough
At 22 hours of growth, we take again the OD Exp01
1A1= 0.266
1A1+Leu= 0.414
BCD= 0.195
BCD+Leu = 0.129
BKDAa= 0.059
BKDAa+Leu= 0.109
BKDAb= 0.122
BKDAb+Leu= 0.124

Exp02
1A1= 0.464
1A1+Leu= 0.508
BCD=0.388
BCD+Leu =0.332
BKDAa=0.328
BKDAa+Leu=0.711
We do then the smell test again (on exp02 tubes expect BKDAB from exp01 on 5 volunteers. We ask the participants to grade the intensity from 0 to 10.) 1A1= 5/7/2/4/2
1A1+Leu= 5/4/2/7/4
BCD=2/3/4/2/3.5
BCD+Leu =2/3/4/1/6
BKDAa=3/6/2/2/3
BKDAa+Leu=2/4/3/1/0
BKDAb=2/5/2/5/3
BKDAb+Leu=3/4/5/7/1.5

19-08-14

To access the capability of the wt and mutant (BKE24040, BKE24050, BKE24080) B.Subtilis to grow in synthetic sweat

Procedure

We inoculated Single colony of both wt (1A1) and mutant (BKE24040, BKE24050, BKE24080) in 5ml of synthetic sweat supplemented w/o EM for wt and with EM for mutants. Incubated the colonies @ 37°C overnight.

Results

No growth observed for both wt and mutant B.subtilis

Date 1

Goal

Text

Procedure

Text

Results

September

Date 1

Goal

Text

Procedure

Text

Results

Date 1

Goal

Text

Procedure

Text

Results

October

Date 1

Goal

Text

Procedure

Text

Results

Date 1

Goal

Text

Procedure

Text

Results