DMS SYNTHESIS

Introduction

Don't you think it is fantastic if the small organism, E. coli, create something huge, like a cloud? You might think we are daydreamers, but we found a clue in some scientists' words. In our project, for forming cloud, we tried to make E. coli which can produce dimethyl sulfide (DMS), a source of Cloud Condensation Nuclei (CCN). In wetlands or sea, specific marine bacteria and coral produce DMS, so we try to obtain the genes related to this synthetic pathway and introduce them into E. coli.

How is cloud produced from DMS?

DMS is a simple volatile material formed through multi-step reactions by some marine organisms. After formed in the ocean, it is volatilized, and decomposed by the ultraviolet rays form the sky. Then it is converted to sulfate aerosol. In nature this sulfate aerosol plays a role as a Cloud Condensation Nuclei (CCN), tiny particles which condense water vapor around itself and form clouds (Fig. 1) [1].

Methionine (Met) - DimethylSulfidePropionate (DMSP) - DMS route is known as one of the DMS biosynthetic pathways. This route consists of Met-DMSP synthetic pathway of certain diatoms and corals and DMSP-DMS metabolic pathway of marine bacteria [2] (Fig. 1).

The structure of each intermediate chemical had been already clarified.(Fig. 2)

They are 4-Methylthio-2-oxobutyrate(MTOB), 4-Methylthio-2-hydroxybutyrate(MTHB) and 4-Dimethylsulfonio-2-hydroxy-butyrate(DMSHB). However, genes responsible for each intermediate reaction of Met-DMSP pathway are still unknown (Fig. 2). And only the candidate genes from Fragilariopsis cylindrus are suggested by Barbara R. Lyon et al. [3]. This organism is a model sea-ice diatom and can produce DMS in Met-DMSP synthetic pathway.

The osmotic pressure of F. cylindrus is controlled by DMSP density (Fig. 3-1). Thus, the authors of the paper hypothesized that proteins which increases under the condition of F. cylindrus producing a lot of DMSP seem to be enzymes which catalyze the DMSP biosynthetic pathway. They compared the proteome of F. cylindrus cultured under high-salinity with another one under general salinity by using 2-dimensional electrophoresis. As a result, they found out that the amount of some proteins increased under high-salinity condition compared to general condition (Fig. 3-2). Taking advantage of the mass spectrometry to these proteins, chemical reaction types in the Met-DMSP biosynthesis pathway and knowledge on substances of known enzymes, they speculated 5 candidate genes (AT, REDOX, SAMmt, DECARB, DiDECARB) that might be assigned to each step.

On the other hand, a gene concerned with DMSP-DMS pathway is identified from another organism. The enzyme which catalyzes the one-step reaction is encoded by the dddD gene. It is reported that dddD gene of Marinomonas sp., one of the marine bacteria, is functional in E. coli. [4]

Depending on these previous works, we speculate that introducing the 5 candidate genes of F. cylindrus and dddD enables E. coli to produce DMS. But it is still unclear whether each of these genes can be finely expressed in E. coli. So we tried to introduce these genes separately into E. coli to verify its expression. In order to investigate whether the candidate proteins properly catalyze each reaction step, we used High Performance Liquid Chromatography (HPLC) to detect each reaction product of Met-DMSP synthetic route. To detect DMS, we used a DMS gas detecting tube.

Experiments

As described in the Introduction section, 5 candidate genes (AT, REDOX, SAMmt, DECARB, and DiDECARB) are considered to be involved in the Met-DMSP synthesis pathway. Also, one gene, dddD, is known to be involved in the DMSP-DMS metabolic pathway. We planned to introduce each gene into E. coli, in order to check the function of each gene one by one (Fig. 4).

1. Cloning of 5 genes from genomic DNAs

First of all, we tried to obtain the target genes from the genomic DNA of each organism. For the Met-DMSP biosynthesis pathway, we purchased the genomic DNA of F. cylindrus, which is used in the preceding study [Barbara et al., 2011]. With respect to dddD gene, which is involved in the final step of DMS synthesis, the function of dddD homolog from Marinomonas sp. MWYL1 strain was verified in E. coli in the preceding study [Jonathan et al., 2007]. However, we used Ruegeria pomeroyi genome for the source of dddD cloning [Jonathan et al., 2007], since the genome of Marinomonas sp. MWYL1 was less commonly available.

We decided to start our project from the confirmation of the R. pomeroyi dddD homolog because its function has not been experimentally verified so far. We first compared the protein sequence of the dddD gene of R. pomeroyi and the homolog from Marinomonas sp. These proteins showed high homology to each other based on the global alignment (41 % identity, 59 % similarity).

Moreover, as a common feature, these proteins share a domain structure with the CaiB protein, which is a predicted acyl-CoA transferases/carnitine dehydratase.

From the genomic DNAs, we amplified the selected genes (AT, REDOX, SAMmt, DECARB, DiDECARB, and DddD) by PCR. However, genes of AT, REDOX, SAMmt, DECARB, and DiDECARB contain introns, because F. cylindrus is an eukaryote. To remove these introns, we performed Overlap Extension PCR (OE-PCR) (Fig. 7). Compared to the PCR products, the bands of the OE-PCR products showed a shorter length, indicating that the introns were removed (Fig.7). Thus, we attained our parts composed of only exons from each gene. We sequenced these parts and confirmed that the introns were precisely removed.

2. Plasmid construction for expressing the genes in E. coli

We constructed the expression plasmids using the amplified PCR products. To date, we completed the dddD generator and the AT generator (Fig. 8). We chose T7 promoter to express the interested genes, so thAT we can overexpress AT gene and dddD gene using E. coli BL21(DE3).

3. Examination of the AT generator

Initially, we were planning to verify the function of AT generator by directly detecting MTOB, the product of AT reaction, by the UV absorption with HPLC. However, it turned out that E. coli produces too many chemicals with similar characteristics to MTOB, rending the direct detection of MTOB difficult. We searched for an alternative method and found a protocol for fluorescent labeling of MTOB.

DMB (1,2-diamino-4,5-methylenedioxybenzene) reacts with α-keto acid specifically and emits strong fluorescence (Fig. 9)[6][7][8]. MTOB is an α-keto acid that should be a good substrate of the labeling. Fortunately, α-keto acids seem to be scarce in the E. coli lysate, making our MTOB detection assay easy.

To evaluate our assay system for MTOB detection, we checked if ,with HPLC, we can clearly detect MTOB in experimental medium containing E. coli lysate, methionine, IPTG, 2-oxoglutarate (necessary for the reaction from Met to MTOB [Summers et al., 1998]) and so on. Pure chemicals (sample 1 and 2) or E. coli crude extract (sample 3) were separated by a C-18 column with acetonitrile gradient.

In Sample 1, a single strong peak at 35.233 minutes was observed, indicating that this peak represents DMB. Similarly, in addition to the DMB peak, there is another strong peak at 34.070 minutes in Sample 2. This peak represents MTOB labeled by DMB, since free MTOB is not fluorescent. Note that the peak for free DMB (35.233 minutes) is less abundant in Sample 2 when compared to Sample1, suggesting the conversion of free DMB to DMB-MTOB conjugates.

As clearly observed, the peak around 34.070 is missing in this sample 3, demonstrating that all the components of MTOB formation without AT generator produce no significant signal at this specific retention time. These results show that MTOB labeling by DMB would be an ideal method to detect MTOB synthesis by AT generator transformants.

Starting from the genomic DNA of F. cylindrus, we have completed the construction of the AT generator. However, unfortunately, we did not use the generator in our detection system described above, as we could not prepare the generator until very recently. So, the much-anticipated results of the AT reaction assay will be obtained in the future. We believe that we can present the detailed results in the coming jamboree this year.

4. Examination of DddD generators

Next, we transformed the DddD generator into E. coli and cultivated the cells in a medium containing DMSP and IPTG , to verify the conversion of DMSP to DMS by the dddD gene product. The cells were grown in a sealed test tube to retain vapor from the culture, as DMS is a highly-volatile compound. The gaseous phase of the culture containing DMS was collected and examined by the DMS Detection tube.

Conclusion

We have completed two plasmids for the partial reconstitution of DMS synthesis in E. coli. We have also established the effective system for the detection of MTOB, a intermediate of DMSP synthesis, by using fluorescent labeling of MTOB in E. coli lysates. For the final step of DMS synthesis, we have successfully detected the conversion of DMSP to DMS in our DddD generator-dependent manner. (we examined the function of DddD homolog in a crude extract of E. coli. Unfortunately, we did not detect significant amount of DMS produced by our DddD generator.)

Future Work

The examination of the AT generator is finally possible and we believe that it works. Also, the step of DddD can be improved as discussed in this study. The next step of this project is to introduce all of the four candidate genes hypothetically involved in this pathway to E. coli. We will try to detect DMS formation directly by adding excess quantity of methionine to the growth media.

What can we do if we achieve the creation of DMS producing E. coli? In nature, biologically produced DMS is evaporated and converted to sulfate aerosol by UV irradiation, which forms cloud condensation nuclei (CCN). What we can try first is to emulate this process in vitro. Experimental demonstration of these reactions will become an intriguing show for the understanding of the global climate system.

Taking a long view, it might become possible for us to spread the engineered bacteria, to manipulate the local climate. However, it is absolutely necessary to establish effective security system before we use engineered organism in nature.

Reference

• [1] Ippei Nagao, Progress and current status of research on dimethylsulfide, Low Temperature Science(2014)
• [2] Douglas A. Gage*, David Rhodes, Kurt D. Nolte, Wayne A. Hicks, homas Leustek, Arthur J. L. Cooperk & Andrew D. Hanson, A new route for synthesis of dimethylsulphoniopropionate in marine algae, Nature(1997)
• [3] Structural and Regulatory Genes Required to Make the Gas Dimethyl Sulfide in Bacteria, Jonathan D. Todd, Rachel Rogers, You Guo Li, Margaret Wexler, Philip L. Bond, Lei Sun,Andrew R. J. Curson, Gill Malin, Michael Steinke, Andrew W. B. Johnston, Science(2007)
• [4] Identification and Stereospecificity of the First Three Enzymes of 3 Dimethylsulfoniopropionate Biosynthesis in a Chlorophyte Alga1, Peter S. Summers2, Kurt D. Nolte, Arthur J.L. Cooper, Heidi Borgeas, Thomas Leustek, David Rhodes, and Andrew D. Hanson, Plant Physiol. (1998)
• [5] Proteomic Analysis of a Sea-Ice Diatom: Salinity Acclimation Provides New Insight into the Dimethylsulfoniopropionate Production Pathway, Barbara R. Lyon, Peter A. Lee, Jennifer M. Bennett, Giacomo R. DiTullio, and Michael G. Janech, American Society of Plant Biologists(2011)
• [6] S.Hara,Y.Takemori,T.Iwata,M.Yamaguchi,M.Nakamura and Y.Ohkura, Anal. Chim.Acta,72,167(1985).
• [7] S.Hara,M.Yamaguchi,M.Nakamura and Y.Ohkura, Chem.Pharm.Bull.,33,3483(1985).
• [8] M.Nakamura,S.Hara,M.Yamaguchi,Y.Takemori and Y.Ohkura, Chem.Pharm.Bull.,35,687(1987).
• []
• []