Team:Cambridge-JIC/Dry Work

From 2014.igem.org

(Difference between revisions)
Line 21: Line 21:
<li>Primers are '''cheap'''. If it's too much effort to reuse primers with your new construct, just order new ones. Spend some, but not a lot, of time if you're thinking of reusing primers to try and save a bit of dollar. </li>
<li>Primers are '''cheap'''. If it's too much effort to reuse primers with your new construct, just order new ones. Spend some, but not a lot, of time if you're thinking of reusing primers to try and save a bit of dollar. </li>
-
<li>Try and make your primers reusable, if they're for a reusable part. Don't just split up your construct in any which way for Gibson. </li>
+
<li>Try and make your primers reusable, if they're for a reusable part. Don't just split up your construct in any-which-way for Gibson. </li>

Revision as of 15:04, 22 July 2014

Home Team Official Team Profile TimeLine Project Outreach Marchantia Informatics Parts Modeling Notebook Protocols Safety Dry Work Technology Attributions

Constructs

  • Delete 5'-UTRs (if in doubt). 5'-UTR's affect expression rates, so if we're comparing promoters/inputs, UTR's will make a big difference. So, for the sake of normalisation, get rid of the 5'-UTRs.
  • If it works, don't change it. Don't go altering spacing in between parts when making constructs!

Primers, Gibson flaps and splitting up constructs

  • With our hi-tec polymerase, each fragment you're PCR'ing up can be up to 5.5kb (reliably). Any more, see if you can re-jig primers to get smaller fragments. i.e. 6kb - 2kb-2kb is not ideal, but 3kb - 4kb - 3kb is fine (or even 5kb-5kb)
  • If you're splitting up your constructs, you don't need to add flaps - just choose primers appropriately!
  • Make the primers. Don't really worry about secondary structures unless it's obvious. Use a melting temperature of >58 degrees.
  • Check that they're correct by searching in the plasmid you're PCR'ing off and the destination construct. Make sure the primer can only prime to 1 place! (e.g. be careful using a nosT/35s region as these are very common)
  • Primers are '''cheap'''. If it's too much effort to reuse primers with your new construct, just order new ones. Spend some, but not a lot, of time if you're thinking of reusing primers to try and save a bit of dollar.
  • Try and make your primers reusable, if they're for a reusable part. Don't just split up your construct in any-which-way for Gibson.

Retrieved from "http://2014.igem.org/Team:Cambridge-JIC/Dry_Work"