Team:ETH Zurich/project/references

From 2014.igem.org

(Difference between revisions)
Line 37: Line 37:
<div id="refR2oDNA" align='left'> </html>[34] [http://pubs.acs.org/doi/abs/10.1021/sb4001323 Casini, A., Christodoulou, G., Freemont, P. S., Baldwin, G. S., Ellis, T., MacDonald, J. T. , R2oDNA Designer: Computational Design of Biologically Neutral Synthetic DNA Sequences, ACS Synthetic Biology, 2013]<html></div>
<div id="refR2oDNA" align='left'> </html>[34] [http://pubs.acs.org/doi/abs/10.1021/sb4001323 Casini, A., Christodoulou, G., Freemont, P. S., Baldwin, G. S., Ellis, T., MacDonald, J. T. , R2oDNA Designer: Computational Design of Biologically Neutral Synthetic DNA Sequences, ACS Synthetic Biology, 2013]<html></div>
<div id="refChang" align='left'> </html>[35] [http://jb.asm.org/content/134/3/1141.full.pdf Chang, A. C. and Cohen, S. N., Construction and characterization of amplifiable multicopy DNA cloning vehicles derived from the P15A cryptic miniplasmid, Journal of Bacteriology, 1978]<html></div>
<div id="refChang" align='left'> </html>[35] [http://jb.asm.org/content/134/3/1141.full.pdf Chang, A. C. and Cohen, S. N., Construction and characterization of amplifiable multicopy DNA cloning vehicles derived from the P15A cryptic miniplasmid, Journal of Bacteriology, 1978]<html></div>
 +
<div id="refWallich" align='left'> </html>[35] [http://spectrum.ieee.org/robotics/diy/3d-printing-takes-shape Wallich, P., 3D-Printing takes shape, IEEE Spectrum, 2011]<html></div>
</article>
</article>

Revision as of 21:17, 17 October 2014

iGEM ETH Zurich 2014