Team:Gifu/Modeling
From 2014.igem.org
Line 118: | Line 118: | ||
<p><img src="https://static.igem.org/mediawiki/2014/6/60/Modelfig10V.png"></img><br><br> | <p><img src="https://static.igem.org/mediawiki/2014/6/60/Modelfig10V.png"></img><br><br> | ||
<img src="https://static.igem.org/mediawiki/2014/f/f8/Modelfig11V.png"></img></p> | <img src="https://static.igem.org/mediawiki/2014/f/f8/Modelfig11V.png"></img></p> | ||
- | <p> | + | <p><img src="https://static.igem.org/mediawiki/2014/b/b2/Modeltable2V.png"></img><br> |
+ | <b>table. 2</b></p> | ||
Revision as of 01:10, 18 October 2014
Modeling
Summary
We examined the efficiency of circularization of mRNA in E. coli. The mRNA synthesized by transcription of induced plasmid may be considered that there are mainly 3 shape patterns in the process of circularization (fig.1).
In this experiment, we carried out reverse transcription of RNA of Escherichia coli, and calculated the abundance ratio of each shape pattern by detecting specific sequences by using MPN-PCR (Most Probable Number-PCR).
By examining the abundance ratio of sequence A, B or C, D , and B / A shows the probability that the reaction doesn’t start (step Ⅰ). Also, we can calculate the probability that RNA will cyclize (step Ⅱ,Ⅲ) by C and D. By examining them, we investigated the rate-limiting step in the process of cyclization or probability to cyclization of the RNA.
Experiment
We extracted total RNA from E. coli and then carried out the reverse transcription. This time we used the two types of primer; oligo dt primer and random primer. And we carried out reverse transcription with them. We serially diluted obtained cDNA, and calculated abundance rate by using MPN-PCR.
Case 1: Determination of the sequence A and B
We carried out reverse transcription with the oligo dt primer which is complementary to the poly A sequence at the 3 'end of the mRNA (fig.2).
Oligo dt primer anneals specifically to the 3 'end of the mRNA, so the ratio of reverse transcription of A and B are the same. Thus, B/A calculated by the MPN-PCR shows the abundance ratio of step Ⅰ, that is, the probability that no reaction started.
Case 2: Determination of the sequence C and D
Since there’s no poly A sequence on the mRNA after starting cyclization, it’s impossible to use the oligo dt primer. Therefore, we use the random primer. However, some problems arise when we determine them with random primer.
Problems
Reverse transcription is carried out in the following steps.
- Primer is added to RNA.
- The cDNA is synthesized by reverse transcriptase.
- Inactivation of reverse transcriptase
It means, if the primer anneals to C or D, this sequence doesn’t exist in cDNA. And if the primer did not anneal at 3' end, C or D don't exist in synthesized cDNA (linear mRNA). (fig. 3)
We calculated the ratio made C or D in cDNA each step when we carried out reverse transcription with random primer.
- The ratio of random primer annealing depended on only base pairs of RNA.
- When mRNA was transcribed from DNA, transcription finished at the same sequence.
- There was no shape pattern of RNA without figure 1.
On the step Ⅰ, when random primer annealed the sequence which is cyclized and its 3’ end, the ratio that D is reverse transcribed is the following.
Step Ⅰ (fig. 4)
Step Ⅱ (fig. 5)
Step Ⅲ (fig. 6)
The C/D calculated in this experiment shows the following.
aⅠand aⅡ show the following.
From the above, by examining the C/D, we are able to calculate the abundance ratio of stepⅢ ; the abundance ratio of the cyclization of the RNA.
Result&Data analysis
About A and B
We carried out PCR and agarose gel electrophoresis (fig.7).
We carried out image analysis. We calculated the intensity of light relatively and then decided whether the objective band detected or not(figure.8 and 9). Judging from the square measure of each peak, we obtained following result (table.1). Table.1 shows a number of the positive fraction.
table. 1
The ratio (B/A) which shows that the reaction doesn’t proceed is expressed the following.
About C and D
We carried out PCR and agarose gel electrophoresis (fig.10).
Figure. 10
We carried out image analysis. We calculated the intensity of light relatively and then decided whether the objective band detected or not (figure.11 and 12). Judging from the square measure of each peak, we obtained following result (table. 2). Table.2 shows a number of the positive fraction.
table. 2
Support from other team
Because our theme “Circular mRNA” is qualitative experiment, we had a hard time with Modeling. That’s why A member of UT-Tokyo thought about the Modeling about our theme.
- Growth curve of E. coli and overexpression of protein by circular mRNA
→How much does the synthesis of long-chain protein influence growth of E. coli?
By comparing our result with control (empty vector or non-plasmid), we decide parameter. We also learnt it from UT-Tokyo that past studies will be good references for these population dynamics.
https://2013.igem.org/Team:British_Columbia/Modeling - Does the strength of circular mRNA depend on the length of exon?
If we can make a parameter which shows how long the insert is the most stable when we had Circular mRNA, this will be helpful for the correction of the model.
We greatly appreciate UT-Tokyo taught us Modeling despite their busy.