Team:Oxford/InterlabDevices

From 2014.igem.org

Revision as of 17:20, 11 August 2014 by TimAng94 (Talk | contribs)

Devices

I. Using the DNA distribution kit to extract devices 1-3:


Devices.png

We filled the 4 wells we needed with 10 uL of dH2O and let it sit for about 10 minutes to resuspend. We transformed the resuspended DNA into chemically competent E.coli cells (DH5) and plated them on an agar plate with kanamycin (plate for device 1) and chloramphenicol (plates for devices 2a, 2b/3b, and 3a) using the standard E.coli transformation protocol (however, we used 200 uL of competent cells per transformation rather than 100uL).

II. Growing liquid cultures:

We collected our plates from the 37°C incubator the following day. All plates had colonies growing on them, so we took one from each for generating liquid cultures.

III. MiniPrep and Sending for Sequencing:

Having let the cultures grow up overnight, we took samples from each culture and used the Miniprep kits to extract each plasmid. Using the Nanodrop to measure the DNA concentration we prepared them for sequencing by SourceBioscience. The 5uL sequencing samples were frozen overnight and then sent for sequencing the next day. The remaining 45uL were stored in the -20⁰c freezer.

IV. Sequencing results:

We received sequencing results that confirmed the sequences of the parts we were using from the DNA-distribution kit, including the two point-mutations in part 3A. Shown below are the sequence alignments of the sequence we expected (top strand) and the sequencing results (bottom) of parts 2A (left) and 3A (right):

Sequence Alignment BBa J23101.png
Sequence Alignment BBa J23115.png






















V. Restriction digest:

The first device is already built, but devices 2 and 3 have to be built. We decided to do a restriction digest of the plasmids. Due to the fact that a restriction fragment of 35bp (parts 2A or 3A) would be hard to detect on a gel, we opened the plasmids containing

Retrieved from "http://2014.igem.org/Team:Oxford/InterlabDevices"