Team:ETH Zurich/lab/chip

From 2014.igem.org

(Difference between revisions)
(3D-Printing and Rapid Prototyping)
(3D-Printing and Rapid Prototyping)
Line 39: Line 39:
===3D-Printing and Rapid Prototyping===
===3D-Printing and Rapid Prototyping===
-
The mold designs were printed with a commercial 3D-printer (2nd generation MakerBot with MakerWare software; ([http://www.makerbot.com MakerBotIndustries]), Brooklyn, US; 5th generation US$2'899) with acrylonitrile butadiene styrene (ABS, a copolymer of acrylonitrile, butadiene, and styrene). The maximum object size printable is [mm]: 225 x 145 x 150. The precision and minimum feature size are given as [mm]: 0.011 (XY-axis), 0.0025 (Z-axis); and 0.4 (XY-axis), 0.2 (Z-axis) respectively. The printing time varied with the size of the mold but was usually below 4 hours.  
+
The mold designs were printed with a commercial 3D-printer (2nd generation MakerBot with MakerWare software; [http://www.makerbot.com MakerBotIndustries], Brooklyn, US; 5th generation US$2'899) with acrylonitrile butadiene styrene (ABS, a copolymer of acrylonitrile, butadiene, and styrene). The maximum object size printable is [mm]: 225 x 145 x 150. The precision and minimum feature size are given as [mm]: 0.011 (XY-axis), 0.0025 (Z-axis); and 0.4 (XY-axis), 0.2 (Z-axis) respectively. The printing time varied with the size of the mold but was usually below 4 hours.  
<gallery mode="traditional" widths=200px>
<gallery mode="traditional" widths=200px>

Revision as of 23:53, 16 October 2014

iGEM ETH Zurich 2014