Team:EPF Lausanne/Results

From 2014.igem.org

Revision as of 21:48, 16 October 2014 by Robert Baldwin (Talk | contribs)

RESULTS


Characterisation of the spatiotemporal dynamics of the CpxR - split IFP 1.4 stress sensor



Experiment 1: Characterisation of the AraC/PBad Promoter and folding ability of GFP fused to CpxR

This construct aimed to evaluate the expression of our construct and the characteristics of the arabinose promoter in E. coli by fusing a superfolder GFP protein to the N terminus of CpxR. The sfGFP was chosen because of its higher intensity compared to GFP.

Not knowing if CpxR would react the same way if sfGFP were attached to the N or C terminus, 2 biobricks were built, one with each of the orientations: BBa_K1486002 (N terminus) and BBa_K1486005 (C terminus).

An experiment on both possible CpxR - sfGFP orientations was launched to determine whether the proteins were well expressed and if the arabinose promoter worked well. It was also done on a microfluidic chip and on the wet bench. The N terminus GFP biobrick results can be seen below; fluorescence intensity plotted as a function of time.




Experiment 2: Demonstration of CpxR's dimerization & Elucidation of its dimerization orientation

Previous in vitro experiments (FRET) have shown that CpxR dimerizes. Currently little in vivo information about CpxR’s dimerization is available. To characterize our stress responsive bacteria, we had to confirm that CpxR dimerized in vivo as well as elucidate CpxR’s dimerization orientation.


We synthesized four constructs with combinations of the split IFP1.4 fragments fused to the C or N terminal of CpxR. As seen in the graph bellow, induction of IFP1.4 signal by 50 mM KCl was done at t=24min. We clearly see that the construct with IFP fragments on the C-terminal immediately responded to stress by emitting fluorescence. In fact we observe a 3 fold signal increase in 2 minutes. On the other hand, the three other orientations were non-responsive to KCl stress.

Construct Comparison

This amazing 30-fold signal increase in little time from the baseline allows us to assert that only the strain synthesizing the IFP fragments on the C-terminals of CpxR responded to KCl stress. For a further analysis of this experiment check out this link!

Experiment 3: Signal induction by various concentrations of KCl & signal shutdown by centrifugation

Aim
Having found that KCl was a good signal inducer for our signal, we decided to characterise our biobrick by testing if the signal could be modulated by various concentrations of KCl and if we were able to remove the signal by centrifugation and medium change. To do so, we read our signal for 20 minutes without stress and then added KCl. At minute 144 we centrifuged our cells and replaced the medium with PBS to be able to get a shutdown of the signal.

Methods
To evaluate if a modulation in KCl concentrations affected the intensity of the intensity of the fluorescent signal, and if a change in medium by centrifugation shutdown the signal; we read our signal on a plate reader for 20 minutes without stress and then added KCl. At minute 144 we centrifuged our cells and replaced the medium with PBS to be able to get a shutdown of the signal. The protocol for this experiment can be downloaded here.

Results
We successfully showed that increasing concentrations of KCl led to stronger signals up to a saturation concentration of about 80 mM KCl. Moreover we were able to shut the signal down, thus proving the reversibility of our system. These results prove the reversibility of the split IFP1.4 and suggest that real-time temporal dynamics analysis are possible for our system.

GA1 Shutdown




Experiment 4: Visualization of the the CpxR split IFP1.4 activation by KCl stress

Aim
Having shown that we were able to monitor the temporal dynamics of our construct, we wanted to see if we were able to analyze the spatial dynamics by microscopy.

Methods
To visualize the activation of our construct, we prepared cells as above for the previous plate-reader experiments, spread 10 µl on a glass slide added a coverslip and imaged them on a Zeiss Axioplan with a x100 objective and a APC (Cy5.5) filter. The pictures shown bellow were taken with a 5.1(s) integration time.

Results
As seen in the pictures bellow, we were able to distinguish specific patterns within bacteria. We observed two phenotypes within our population: elongated and normal cells. The difference in these phenotypes was noticed in previous experiments and is most certainly due to the CpxR overexpression as we observed this also in non-stressed conditions. In the first phenotype (elongated) we were able to distinguish several bands that seem fairly uniformly distributed. In the second phenotype (normal) we observed a single band in the center of the bacteria. These observations led us to believe that CpxR might be involved in the division process of E. coli as it seems coherent for cells to slow down division upon stress. After looking into the literature, similar bands were visualizable in E. coli for factors related to septum formation such as ftsZ or pbpB. Nevertheless when comparing our patterns to the ftsZ and pbpB patterns, we noticed that CpxR might be localized in opposition to these factors. Further experiments comparing the sub-localization of CpxR and ftsZ could help the scientific community better understand how E. coli monitor division under various environments.

















Characterisation of the split luciferase



Experiment 1: CheY/CheZ fused to split Firefly/Renilla luciferase, and full Firefly/Renilla luciferase characterisation

Introduction
CheY and CheZ are two proteins involved in the bacterial chemotaxis pathway. It has been shown by split luciferase complementation assay that these two proteins are not interacting in presence of chemoattractant, but start to interact (CheZ being the phosphatase of CheY) in absence of chemoattractant or presence of chemorepellent. Based on the work of Waldor1 Laboratory, we wanted to redo and adapt the experiment to test our own splits.

Aim
This experiment aimed to test the efficiency of split Renilla luciferase and split Firefly luciferase. We wanted to study the speed of the signal and the amount of substrate needed to have a performant response.

Method
To proceed to this complementation assay, we built two constructs, one to test split Renilla Luciferase and the other for split Firefly Luciferase The CheY was fused to the N-terminal part of each split, while the CheZ was fused to the C-terminal part. We used the full luciferases (Renilla : BBa_K1486022 and Firefly : BBa_K325108 from Cambridge 2010 team) as positive controls and the non-fused splits (Renilla : BBa_K1486021 and Firefly : BBa_K1486018 ) as negative controls.

The bioluminescence assay was performed as described here.
The constructs were designed and assembled as described here.


Results
As shown in the graphs below (fig.1A and 1B), we couldn't really observe a high signal for our complementation assay. However, the signal being higher than the blanks, it is an encouraging sign that the splits luciferase can be used for other experiments of this kind. A possible explanation for these results is that arabinose being a chemoattractant, we might need to do more wash steps with PBS to get rid of the arabinose before taking the measurements. Moreover, CheY and CheZ being endogenously expressed in bacteria, the edogenous proteins could interfere with our fusion proteins and weaken our signal. This complementation assay should be tested with CheY/CheZ knock out strains, as it was done in Waldor Laboratory.


cheYcheZ cheYcheZ


We also could determine which of the luciferases would best suit our following experiments. As shown in fig. 2, for the same concentration of substrate, we see that firefly luciferase has a more stable and higher signal. Moreover, the difference between the background noise (negative control, non fused split luciferase) and the full luciferase is bigger for Firefly luciferase, which is also preferable.


Microfluidic Achievements

Experiment 1:

Microfluidic Accomplishments

MITOMI MITOMI modified SmashColi BioPad FilterColi CleanColi
Full chip





Unit Cell




Designed
Mold fabrication
Fabrication of the chip
Application
Reference MITOMI paper

Experiment 2: Culturing E. coli with constitutive GFP on chip

We loaded E. coli, which contained constitutive GFP, in the chip. By using LabVIEW, a protocol was launched overnight to ensure the growth of the cells (the protocol can be found here).

The next morning, a scan of the chip was done to see the intensity of the GFP in the chip.


Experiment 3: CpxR linked with GFP on the N terminal, induced by arabinose in E. coli

The experiment that was done on wetbench to show that CpxR linked with GFP was expressed with an arabinose promoter was replicated on a MITOMI chip. LB medium with arabinose was flowed in the upper half whereas LB medium without arabinose was flowed in the lower half. We scanned every hour for 5h (to know how it was done click here).


Figure 1. Scan of the microfluidic chip at t = 0min. No signal is detected

Figure 2. Scan of the microfluidic chip at t = 300min.

We analysed the scans and obtained the following results.

Figure 3. Evolution of CpxR-GFP fluorescence over time

Characterization of the PBS2-HOG1& split Renilla Luciferase stress-sensitive response

Experiment 1: Confirmation of successful transformation via whole Renilla Luciferase tag

Aim
Transforming S.Cerevisiae cells for the first time, our first experiment consisted of the confirmation of whole protein tag transformations as a positive control for subsequent experiments and the determination of which concentration of substrate for the luciferase we should use.

Methods
Linear fragments containing homologous regions to the target gene surrounding our Luciferase tag and selective markers were created by overlap PCR from GFP tagging plasmids from AddGene. S.Cerevisiae cells were transformed to obtain two different strains : HOG1-rLuc and PBS2-rLuc.The strains were then tested in a 96 well plate using a plate reader.

Results
The test was performed using two different concentrations of the substrate, coelenterazine-h(benzyl coelenterazine) : 1μM and 5μM. The plate started to be read directly after addition of the substrate in the dark and measures were taken every 56 seconds thereafter. Three wells for each sample were measured and below are shown the graphs of their average plotted over time. The results are shown in the figure below. We observed a signal-to-noise ratio of 4 at 1μM of substrate and 10 at 5μM for the PBS2-rLuc strain. The HOG1-rLuc strain died quickly in the plate, and we had to reproduce the strain, of which we have not been able to confirm the success yet.

References

1: S.K. Hatzios, S. Ringgaard, B. M. Davis, M. K. Waldor (2012, August 15). Studies of Dynamic Protein-Protein Interactions in Bacteria Using Renilla Luciferase Complementation Are Undermined by Nonspecific Enzyme Inhibition. Plos One.

Sponsors