Team:Aachen/Collaborations/Methane Sensor
From 2014.igem.org
m (→A low-cost DIY methane sensor for Team Braunschweig) |
m (→A low-cost DIY methane sensor for Team Braunschweig) |
||
Line 12: | Line 12: | ||
To set up the electronics for a measurement, the sensor and the Arduino have to be collected according to the following schematic: | To set up the electronics for a measurement, the sensor and the Arduino have to be collected according to the following schematic: | ||
- | {{Team:Aachen/Figure| | + | {{Team:Aachen/Figure|Aachen_Collaboration-BS-Schematic.png|title=Connecting the MQ-4 module to the Arduino|subtitle=only three wires are required to connect the MQ-4 module to the Arduino Nano.|width=700px}} |
= Serial Client - a WPF application to log data = | = Serial Client - a WPF application to log data = |
Revision as of 19:55, 26 September 2014
|