Team:Groningen/Template/MODULE/Notebook/toolbox/week5

From 2014.igem.org

Revision as of 18:02, 17 October 2014 by S.Mous (Talk | contribs)

4 - 10 August
 
Because the PCR products of NisA, PNisI and sfGFP(Bs) were lost during the purification and restriction in the week of 28 July - 3 August, the PCR was repeated for this genes, together with the genes that could not be amplified yet. This time a PCR was used that did not lower in temperature, like the touchdown PCR, but that increased in temperature with each step. This way it was hoped to get over the huge gap between the annealing temperature of the primer in the first cycle and the annealing temperature of the primer when the flap of the primer can also anneal to the first PCR products. The temperature was set to increase from 40 °C to 60 °C in 20 cycles. Then, an additional 20 cycles were done at 65 °C. The PCR was performed under standard conditions as was done before, together with a series of PCR that contained GC buffer (supplied with the Phusion DNA polymerase by Thermo Scientific), and a series of PCR with GC buffer and 1.5% DMSO. This time, with the help of Lisa, the PCR was finally successful for all genes, see figure 3.
 
Figure 3
 
Figure 3: PCR products of all the genes of the nisin operon with BioBrick prefix and suffix.